Home/Products/Encoder Signal Processing/EasyLink

ENCODER DIVIDER · MULTIPLIER

EasyLink

Encoder Multiplier · Divider Coming soon

Divides or multiplies an encoder signal at a different ratio per channel and distributes it to multiple devices.

Models4CH8CH

This product is coming soon. Specifications are development targets and may change.

EasyLink Encoder Multiplier · Divider
÷ ×Per-channel divide · multiply
40 MHzEncoder input (×4 count)
1 → 8Up to 8 output channels
FAULTEncoder break / short detection

THE PROBLEM

Low-resolution encoders (e.g. 10 PPR) can’t resolve position finely, while fast encoder signals may be too fast for a PLC.

HOW SYNEX SOLVES IT

Sets a multiply/divide ratio per channel and delivers the right pulse rate to each device.

Key features

01

Per-channel divide · multiply

Reduce (divide) or increase (multiply) pulses at any ratio on each output.

02

No cumulative error

Total output count always matches the set ratio exactly. Multiplication is based on constant-speed sections.

03

Per-channel direction invert

Swap A/B direction per output to match each device’s coordinate system.

04

Multi-channel output

One input to 4 / 8 independent output circuits — clean signals with no cross-talk.

05

Break / short detection

LED and error contact on encoder break or short. Monitors phase error and over-speed.

06

Configuration software

Set and check per-channel ratios and status over USB / RS-485.

Configurator — per-channel divide/multiply settings (example)

Software

Software

Configurator — per-channel divide/multiply settings (example)

How it works

EncoderA/B/Z differential
EasyLinkPer-channel divide · multiply
OUT1 1 : 1Motion controller
OUT2 × 2EasyTrigger
OUT3 1 / 10PLC · Counter

Per-channel divide · multiply

Input OUT1 ÷2 OUT2 ×2

Multiplication is based on constant-speed sections · total output count always matches the set ratio (no cumulative error)

Specifications

InputA/B/Z differential (RS422), up to 40 MHz (×4)
Output4 / 8 CH, RS422 differential A/B/Z
Divide / multiplyPer-channel ratio, direction invert
MonitoringBreak/short, phase error, over-speed, error contact
InterfaceUSB, RS-485 (Modbus RTU)
Power5 VDC
ConnectorD-SUB 9-pin (1 input + 4 / 8 outputs)

※ Specifications are subject to change without notice. Contact us for detailed specifications.

Applications

Industry

Inspection · Measurement equipment
Adjust line-scan capture pitch (multiply)Connect to slow-input PLCs (divide)Share one encoder across multi-axis equipment

Use cases

  • One encoder shared by motion controller, trigger and PLC
  • Multiply to tune line-scan pitch, divide to match PLC input speed

Let’s check if it fits your machine

Tell us your machine setup and signal specs — we’ll start by reviewing whether it applies.